Промышленное предприятие ЗИП

Range of products

Показать фильтры товаров
Показать категории

Glue for paper and vinyl wallpaper Grizzly

Download sanitary and hygienic conclusion Download technical card
Write expert
    • Drying time

      24 hours to full drying

    • Coverage

      1 pack per 8-10 rolls

    • Thinner

      Water

    • Type of works

      Interior

    • Containers

      0,25 kg

The value of the product:

  • Does not form lumps
  • Ready for applying after 3 minutes
  • It is easy to correct the joints
  • The possibility of storing the premix for up to 8 days at room temperature in a closed container

Purpose:
For all types of paper (light, heavy, dense, washable) and vinyl wallpaper

Surface preparation:

  • The surface must be clean, dry and free of grease
  • Remains of old wallpaper must be removed
  • Previously painted surfaces should be sanded with sandpaper
  • Intensively absorbing surfaces must be primed with an acrylic primer or diluted glue first and then allowed to dry
  • After that, apply glue to the wallpaper, prepared according to the proportions indicated in the table

Mode of application:

  • Pour room temperature water in a clean container in the amount indicated in the table
  • Gradually pour out the contents of the packet with constant stirring
  • Wait 3-5 minutes before thickening. Stir vigorously until smooth
Assignment Water, liters/packet Number of rolls* Square, m²
Priming of the surface 12,5 75
Lightweight paper wallpaper 9 8-10 55
Thick, corrugated, duplex wallpaper 7,5 6 35
Lightweight vinyl wallpaper 7,5 5-6 30
Heavy vinyl wallpaper 6,5 5 28

* Standard wallpaper roll 10,05 m х 0,53 m

Gluing the wallpaper:

  • Cut a wallpaper roll into sheets equal to the height of the wall +10 cm, if necessary, taking into account the features of the picture
  • Apply glue on the back of the wallpaper with a uniform layer, carefully blurring the edges
  • Bend the edges to the middle of the glued side
  • Give the glue some time to soak
  • The time depends on the type of wallpaper (follow the instructions of the wallpaper manufacturer)
  • The first cloth is glued strictly vertically (by plumb line), starting from the top of the wall and retreating 40 cm from the corner of the room or window
  • The pasted sheet is smoothed with a dry cloth, brush or spatula from the center to the edges, removing air bubbles
  • The next sheet is glued to the back with the previous one
  • From below, the wallpaper is cut off with a wallpaper knife and a ruler

Recommendation:

  • Work at a temperature from +10 ° C to +35 ° C and humidity of 60 ± 5%
  • During the gluing of the wallpaper and until it dries completely, keep the windows and doors indoors closed

Tools: Brush, roller

Solvent: Water

Storage, transportation and disposal:
Keep out of children’s reach. In case of contact with eyes, rinse immediately with clean water. Protect from frost. Keep at dry and cool place at a temperature not lower than + 5°C and not higher than + 35°C, protected from direct sunlight.
Closed containers with residues have to be recycled municipal waste collection sites.

Оur brands
Оur partners
закрыть

Fieldset

 

Verification

закрыть

Supplier Data

  • Section

 

; preloader