Промышленное предприятие ЗИП

Range of products

Показать фильтры товаров
Показать категории

Structural acrylic plaster bark beetle TRIORA

Download sanitary and hygienic conclusion Download technical card
Write expert
    • Drying time

      4-6 hours at a temperature +18-22°С and 65% RH

    • Coverage

      1-1,5 ml: 2,2-2,4 kg/m²

    • Type of works

      Interior, Exterior

    • Containers

      20 kg

    • Drying time

      24 months

The value of the product:

  • Durable
  • Elastic – resistant to micro cracks
  • Contains wax – high water resistance
  • Easily structured

The appointment of the product:
Using for the protection and decoration of the surfaces with a high operational load outside and indoors. The product could be used as a finishing layer in a thermal insulation system, which are using expanded polystyrene boards. Forms a characteristic furrowed surface, creating the “bark beetle” effect

The mode of application
Surface preparation:

  • The surface must be clean, dry, strong and free from grease
  • The surfaces previously coated with chalk, glue, lime or silicone paints should be cleaned out from these materials before using the product
  • Fresh cement plasters could be processed only since 28 days after treatment
  • If there is mold or fungus on the surface, they must be removed with the help of using the TM TRIORA BIO safety devices
  • The base must be prepared and the depressions more than 2 mm should not be
  • For priming crumbling, as well as intensively absorbent surfaces (aerated concrete, gypsum), use the Strengthen primer with the deep penetration by TM TRIORA

NECESSARILY: before the product applying use Quartz adhesive primer for putty TM TRIORA, tinted in the same tone with the plaster

Application:

  • Before using, the paint must be mixed thoroughly
  • Could be applied undiluted or, if it is necessary, diluted with the water to get good viscosity (but not more than 1% of water)
  • Must be applied using a stainless steel spatula from the bottom upwards to the grain size. After the applying plaster ceases to adhere to the tool, it is possible to form the structure of “bark beetle”
  • The surface must be treated with a plastic float in the chosen direction parallel to the surface

Important! Freshly applied plaster should be protected from the rain for 24 hours

Storage, transportation and disposal:
Keep out of children’s reach. In case of contact with eyes, rinse immediately with clean water. Protect from frost. Keep at dry and cool place at a temperature not lower than + 5°C and not higher than + 35°C, protected from direct sunlight.
Closed containers with residues have to be recycled municipal waste collection sites.

Оur brands
Оur partners
закрыть

Fieldset

 

Verification

закрыть

Supplier Data

  • Section

 

preloader