Finishing Putty «FINLAND» TRIORA active
-
Drying time
4-12 hours at +18-22°С and 65% RH
-
Coverage
1,6 kg/m² for 1 mm layer thickness
-
Thinner
Water
-
Type of works
Interior
-
Containers
1,5 kg, 5 kg, 8 kg, 16 kg
-
Drying time
24 months
Value of the product:
- White after drying
- Filling material – calcium carbonate
- Layer falls to 3 mm without cracking
- It can be used as filler as the starting and finishing for alignment
- Easy to application
- Easy to sand
- Can be applied by airless spray
Recommended uses:
For partial and complete surface puttying, for levelling of minor roughness and defects of up to 3 mm before applying finishing coating inside premises (painting, decorative plasters, wallpapers, etc.)
Application guidelines:
Surface preparation:
- The surface should be clean, dry, solid and degreased
- The surfaces that were previously covered with chalk, glue, lime or organosilicone paints should be cleaned up to complete removal of the old coating
- If there is mould or fungi on the surface, use TRIORA prof Bioprotective Agent TR-25 bio to remove them
- To ensure proper surface preparation, extend operational life of the coating and reduce paint consumption, the surface should be previously treated with TRIORA active CHILE Acrylic Primer or PERU Priming Concentrate
- Highly absorptive (aerocrete, gypsum) and peeling surfaces should be primed with TRIORA prof Reinforcing Deep Penetration Primer TR-23 strong
- Major roughness and fractures should be levelled with TRIORA prof Water-resistant Acrylic Putty TR-12 power
Application guidelines:
- The putty is to be applied with a putty knife or a sprayer with up to 0,3-0,5 mm layer thickness
- Before final finishing, the puttied surface must be polished with fine sandpaper
ATTENTION! Not to be used on surfaces which are under continuous exposure of water, in places with increased humidity. In these cases, TRIORA Facade Putty is recommended
Storage, transportation and disposal:
Keep out of children’s reach. In case of contact with eyes, rinse immediately with clean water. Protect from frost. Keep at dry and cool place at a temperature not lower than + 5°C and not higher than + 35°C, protected from direct sunlight.
Closed containers with residues have to be recycled municipal waste collection sites.